Parts| Jackson Exit Device

When you purchase panic and exit devices from RBA Door, every product will meet local building codes as well as your expectations for performance and quality. All panic device hardware and accessories are built with durability, convenience and value in mind. No matter the project, our panic devices are a well-built choice at a reasonable price.

Filter
View as Grid List

28 Items

per page
Set Descending Direction
  1. Jackson Panic Device Top Bolt Guide Assembly 1085/1285/2086

    The Jackson Panic Device Top Bolt Guide Assembly is used on the 1085, 1285, and 2086 hardware.  The piece works by sliding over the top rod when the device is opened. This keeps the rods retracted until the Plunger hits the Trip Assembly when it is closing.  Upon hitting the Trip Assy, the plate slides over and the rods retract.  It measures 1-1/2” deep x 1-1/16” wide x  15/16” tall, with a hole spacing of 3/4" on the mounting screws.   Assembly includes the mounting screws.  The Jackson Part number is 30-934.

    G108518
    $43.84
  2. Jackson Panic Device 1085/1285/2086 Bottom Bolt Guide Assembly

    The Jackson Panic Device 1085, 1285, and 2086 Bottom Bolt Guide Assembly is the piece that fits in the bottom of the door.  It is there to take up slack in rod, so the door can not be shaken open.  Jackson part number 30-320.

    G108556
    $26.30
  3. Jackson Panic Device 1085 And 1095 Dogging Pin

    The Jackson Panic Device 1085 And 1095 Dogging Pin is the piece that keeps the hardware in the open position during business hours.  It is activated by pressing the crossbar and then turning the flat head screw driver head.  The pin is held in the housings with a screw, which is located on the back of the housing.  This pin has been used since about 1988 or so, the old style are no longer made, but they had a roll pin that was used to hold it in place.  This package comes with a new spring, set screw and the pin.  The Jackson part number on this is 30-1115.

    G108554
    $20.45
  4. Jackson Panic Device 1085 Body Package

    The Jackson Panic Device 1085 Body Package includes 4 mounting studs, 3 housing set screws, 2 lever arm springs, 2 lever arm pins, and an actuator link.  Jackson part # 30-1409

    G108534
    $32.14
  5. Jackson Panic Device Mounting Stud 1085/1095

    The Jackson Panic Device Mounting Stud is for use on the 1085 and 1095 panic hardware. Each door would have 2 on the left and 2 on the right, so a total of 4 studs per door. The housings fit over these studs and are held in place by an 1/8" set screw, there are two of these set screws at the top and one on the bottom. The threaded part has a 1/4-20 thread.
    G108544
    $4.39
  6. Jackson Panic Device Crossbar 1085/1095

    The Jackson Panic Device Crossbar is for use on the 1085 and 1095 hardware.  The bar is 45" long and can be cut in the field with a chop saw or hack saw.  There is a groove the entire length of the bar for added and strength and for the thread forming screws to thread into.  The Jackson part number is 30-733-PKG, and it ships with the cross bar screws. 

    Jackson Part # 30-744PKG or 30744PKG

    Door Closer Stop Colors

    G108520-
    As low as $99.35
  7. Jackson Panic Device Crossbar Screw 1085/1095

    Jackson Exit Device Crossbar Screw 1085/1095

    Self threading screw cuts its own threads into the extruded aluminum crossbar.

    Jackson Part # There is not a part #. Jackson only sells the screw as a package with the crossbar.

    G108516
    $1.47
  8. Jackson Panic Device Center Case 1085/1095

    The Jackson Panic Device Center Case 1085/1095 is for use with the 1085 devices for both and left, and the inactive case of the 1095.  Case is easily removed by loosening the two 1/8" Allen screws and one on the bottom.  Includes everything in the housing.  The distance between the mounting studs on this Case is 6-5/16"

    Jackson part # 30-982 Right Hand Body and Arm Assembly
    Jackson part # 30-983 Left Hand Body and Arm Assembly

    Housing Shown in Aluminum

    G1085XX
    As low as $109.59
  9. Jackson Panic Device 1095 Active Housing

    The Jackson Panic Device 1095 Active Housing is the working side of the 1095 panic hardware.  The housing comes will all the internal parts, including the latch bolt.  The distance between the mounting studs on this case is 6-5/16".  Jackson part # 30-988 Right Hand Body, and part # 30-989 Left Hand Body

    Left Hand Housing shown in the aluminum finish.

    G1095xx
    As low as $168.00
  10. Jackson Panic Device 1095 Standard Strike

    The Jackson Panic Device 1095 Standard Strike is a strike they have been using for the past 20 years.  You might have one of the older roller strikes, but this will work in its place.  The older style roller strike is no longer available.  Jackson Exit Device part # 30-2436.

    G109556
    $52.59
  11. Jackson Panic Device Top Bolt Trip 1085/1285/2086

    The Jackson Panic Device Top Bolt Trip is for use on the 1085, 1285, and 2086 devices.  The 30-824 Trip Assembly mounts on the jamb stop and has a pin that sticks out of it (actually a threaded set screw).  The pin lines up with the release plate on the Top Bolt Guide Assembly, when the pin hits the top plate as the door closes, it releases the rods, so they can extend.

    G108558
    $17.54
  12. Jackson Panic Device 1085 and 1095 Thumb Piece Dogging Pin 30-1117

    The Jackson Panic Device 1085 and 1095 Thumb Piece Dogging Pin 30-1117 is a replacement for the Screw Driver Headed Dogging Pin.  Now instead of using a screw driver you can use the handy thumb piece instead.   The package comes with new set screw, spring, and of course the pin.  Jackson part number 30-1117.

    G108554TP
    $29.40
  13. Jackson 1085 30-1242 / 30-1243 Lever Arms

    The Jackson 1085 30-1242 / 30-1243 Lever Arms are for use with the Jackson 1085 Housings, both sides.  And the Jackson 1095 Inactive (hinge side) Housings.  To determine hand, stand inside and look out the door, what is side is the arm on?  If it is on the Right then order Right.

     

    Door Closer Stop Colors

    G10852x
    As low as $43.84
  14. Jackson 1095 30-1247 / 30-1248 Lever Arm

    The Jackson 1095 30-1247 / 30-1248 Lever Arm.  Replacement Lever Arm for the Jackson 1095 Active Housings.   This arm will only work on the 1095 Active Case!  The difference between this arm and the 1085 arm is the Pin in in the top of the arm.   The pin fits into the triangular linkage clip, which actuates the latch bolt.  Handing is determined by standing inside and looking out, if the arm in on the right hand side of the door, it is a right hand lever that you would order.

    G10955X
    As low as $43.84
  15. Jackson 1095P Paddle Panic Hardware

    The Jackson 1095P Paddle Panic Hardware is an alternative to the cross bar or push pad style panic hardware.  The device is the same as the Jackson 1095, but with a paddle instead of the cross bar.   This device is for use on aluminum or steel doors only.   The device is mounted on surface studs that are tapped into the door.  On a wood door they will pull out.

    Right Hand Reverse Shown

    exit device handing diagram

    Falcon Doromatic Jackson Finishes

    1095P-
    As low as $126.00
  16. Jackson Panic Device 1295 Push Pad End Cap Package

    Jackson Panic Device 1295 Push Pad End Cap Package

    Package includes two end caps, one bracket mounting screw, and 4 end mounting screws. This product was just upgraded to a metal cover, which will replace the old plastic cover.

    Old Jackson part # 30-2677
    New Jackson Part # 30-2654

    G302677-xx
    As low as $71.97
  17. Jackson Panic Device 1285 Push Pad End Cap Package

    Jackson Panic Device 1285 Push Pad End Cap Package

    Package includes two end caps, one bracket mounting screw, and 4 end mounting screws. This product was just upgraded to a metal cover, which will replace the old plastic cover.

    Old Jackson part # 30-2661
    New Jackson Part # 30-2652-628 or 30-2652-313

    G302661-
    As low as $71.97
  18. Jackson 30-2674 1285/1295 Cover Package

    Jackson 30-2674 1285/1295 Cover Package

    Jackson part # 30-2674-313 and 30-2674-628 Cover Plate for use on the 1285 and 1295 devices..  Plates measure 2-11/16" x 7-1/2 and 2-11/16" x 2-1/8", two plates in each package.

    Jackson Part #'s 30-2674-313 and 30-2674-612

    G302674-
    As low as $46.76
  19. Jackson 30-2650 Push Bar End Cap 1285/1295

    The Jackson 1285/1295 Push Bar End Cap Package comes complete with the right and left side caps, mounting bracket and screws.  This piece is available in aluminum (silver) and dark bronze (dark brown).

    Jackson Part # 30-2650

    G302697-
    As low as $59.91
  20. Jackson Panic Device 2085 Dogging Assembly LH/RHRB

    Jackson Exit Device 2085 Dogging Assembly LH/RHRB

    This Jackson Exit Device dogging assembly is used on the 2085 Device made after October 1, 1999. It will work on the previous version of this exit device, but you may have to use a file a remove some material from the catch.

    Jackson Part # 30-2462

    This spring would be for the Device on the Right, shown below.

    exit device handing diagram

    G302462
    $20.95
  21. Jackson Panic Device 2085 Dogging Assembly RH/LHRB

    Jackson Exit Device 2085 Dogging Assembly RH/LHRB

    This Jackson Exit Device dogging assembly is used on the 2085 Device made after October 1, 1999. It will work on the previous version of this exit device, but you may have to use a file a remove some material from the catch.

    Jackson Part # 30-2467

    This spring would be for the Device on the Left, shown below.

    exit device handing diagram

    G302467
    $20.95
  22. Jackson Panic Device 20-1266 2085/2095 End Cap

    Jackson Exit Device 2085/2095 End Cap

    The Jackson Exit Device 2085/2095 End Cap measures 3-1/8" high, by 1-1/8" wide, and has a projection of 1-15/16". The mounting lugs are 1-3/8" on center and project out 1".

    Jackson Part Number 30-1266-628 Aluminum
    Jackson Part Number 30-1266-313 Dark Bronze

    G301266-
    As low as $58.37
  23. Jackson 30-1345 Top Strike Package for the 2085-3185

    The Jackson 30-1345 Top Strike Package for the 2085-3185  is mounted on the frame of the door were the top latch can engage it.   The Package includes the Strike, Plate, Latch Adjusting Wrench and the Mounting Screws.   Jackson Part Number 30-1345.

    G301345
    $38.71
  24. Jackson 300846 1085/1285/2086 Strike Package

    The Jackson 30-1345 Top Strike Package for the 2085-3185  is mounted on the frame of the door were the top latch can engage it.   The Package includes the Strike, Plate, Latch Adjusting Wrench and the Mounting Screws.   Jackson Part Number 30-1345.

    G108588
    $21.92
View as Grid List

28 Items

per page
Set Descending Direction