Dogging Assembly | Dor-O-Matic

Filter
View as Grid List

4 Items

per page
Set Descending Direction
  1. Doromatic 1390 Dogging Kit PB-96

    Dor-o-Matic 1390 Dogging Assembly. If you have a 1390 and the dogging is stripped, this is the part you need. The package includes the Dogging Cam (4270102815), Activating Cam (4270106551), Spacer (4270108584), and Retaining Ring (4299100732).  The 1390 was discontinued in about 2003. Also known as a PB-96 Dor-o-Matic 1390 Dogging Assembly

    Doromatic part # 4270106669

    G4270106669
  2. Dor-O-Matic 1690/1790/2390 Dogging Assembly PBX-16

    Dor-O-Matic 1690/1790/2390 Dogging Assembly PBX-16

    Falcon Doromatic 1690, 1790, and 2390 replacement dogging assy. The dogging assembly is used to dog the door in the open position, so people can enter the building without having to unlatch the door for the inside or with a key on the outside.  The KIT.1197 comes complete with mounting screws.   Some of the earlier version where riveted into the rail, so you might need to drill out the rivets, the screws shipped with KIT.1197 have self tapping thread forming screws.

    Doromatic part # KIT.1197

    Dor-o-Matic 1690 Repair Parts Breakdown
    Dor-o-Matic 1790 Repair Parts Breakdown
    Falcon / Dor-o-Matic 2390 Parts Break Down

    GPBX16
  3. Dor-O-Matic 1690/1790/2390 Dogging Hex Shaft

    The Dor-O-Matic 1690/1790/2390 Dogging Hex Shaft is the piece that your dog key (allen wrench) fits into the lock the device in the open or dogged position.  This shaft is used on the 1690, 1790, and 2390 device.  The Dor-o-Matic Panic Devices have been around since the late 1960’s, but have most recently been known as the Falcon Panic Device from a name change they had in about 2008.  They are basically the same device, with the same parts, just a different name plate.  The part that the hex key fits into is only about 1/4" deep, because of that these tend to get rounded out, so the key will not move the shaft. 

    To remove the old shaft just pull with a pair of Channel Locks or Pliers.  To reinstall, just press it back in to position, you might have to bend the holding tabs back down, but we very rarely have to do this.  The manufacture part number on this is SHAFT.101.

     

    GPBX16-SHF
View as Grid List

4 Items

per page
Set Descending Direction