Floor Door Stops and Holders| Ives
Our wide range of door stops and holders are exactly what’s needed to keep the entryways in your building efficient and presentable.
They make it easy to haul large loads into a building as well as protecting the interior and exterior walls from damage and wear. Since 1970, we’ve supplied everything your commercial business needs to fully outfit your entryways and high traffic areas. That’s why we carry a wide range of floor door stops and holders to suit your needs.
-
Floor Door Stop / Holder FS446
Floor Door Stop / Holder FS446
The Ives FS446 Door Stop and Holder is a modification of the FS444, which is the non holder version. It is considered a manual type floor holder, because you have to manually latch the holder for it to hold the door open. It is constructed of cast bronze or brass, and is no longer available in a cast aluminum. It is designed for doors with up to 2-1/2" of undercut, meaning the distance between the finished floor and the bottom of the door. It measures 3-3/4" overall height with a 2-1/2" diameter, and the distance from the base to the center line of the rubber non-marring stop is 2-1/2". This stop is packed with expansion shield and lead shield.
GJF26- -
Floor Door Stop / Holder
The F20 or GJF20 was a mainstay of Glynn-Johnson for years. When the Glynn-Johnson door stop line merged with H.B. Ives it became the FS20. This door stop has been discontinued from Ives, but we have been able find a large stock. This Floor Mounted Door Stop also holds the door open, when in the latched position you can push the door and the holding latch will flip up and unlock thee holding clip. It is constructed of cast bronze or brass and then plated to your desired finish. This stop has a 2-1/2" long base that is 1-1/2" wide. The overall height is 3-1/8" with a 2-5/16" floor to rubber stop centerline. For use with door undercut up to 2-1/2".
GJF20- -
Floor Door Stop-Security FS18
Floor Door Stop-Security FS18 is designed for areas of high vandalism. The molded rubber is flame resistant and mounted to a 5/8" threaded mounting shaft. Once the 7/8" diameter hole is drilled to a depth of 2-1/2" it can be grouted in concrete and leaves no exposed fasteners. The recommended grout is Thorogrip. They are ideal for jail or security cell areas. There are two versions of this door stop one projects 1-1/2" (FS18S) out of the floor and the other 3" (FS18L).
GFS18-